The Comfort motor control unit with integrated power supply unit transmits move commands from central control units to up to 2 sun shading products with 230 V drives. The installation is either surface-mounted or in-line. The unit generates the 24 V DC control voltage for controlling the motor control unit with a push button or the sun shading control system.

Doubly powerful

The motor control unit runs up to 2 230 V drives of sun shading products.

Straightforward

Tilt control mode: motor limit position recognised by current monitoring.

Direct

The time mode allows for simple, direct control of slat products.
  • Direct control of up to two 230 V sun shading drives via a sun shading control system and a local push button
  • Multiple motor control units can be combined into a group and controlled jointly with one push button.
  • The local formation of groups is performed by diverting the encoding switch.
  • Push button operating mode: Time mode with tilt control mode
  • ZL: In time mode, the MSE enters lock mode after the push button is pressed for approx. 2 seconds. Operating the push button for a shorter duration generates a tilting impulse.
  • Tilt control mode: Slats are automatically tilted up immediately after lower limit position is reached (motor limit position recognised by current monitoring)
  • Tilt angle of the slats can be adjusted
  • Control program for WAREMA external venetian blinds with work setting (snap-action switch and pulse tilting)
  • Integrated power supply unit generates 24 V DC control voltage
 Article number: 1002678

Description

Value

Operating voltage

230 V AC

Control voltage

24 V DC

Output

2 x 230 V AC

Switching capacity per drive

500 VA at 230 V AC

Logic behaviour

ZL with tilt

Degree of protection

IP 30

Safety class

I

Type of installation

DIN rail-mounted (REG)

Subassembly width

6 MW