The Compact motor control unit with integrated power supply unit transmits move commands from central control units to up to 6 sun shading products with 230 V drives. The installation is either surface-mounted or in-line. The unit generates the 24 V DC control voltage for controlling the motor control unit with a push button or the sun shading control system.

With several connections

The motor control unit runs up to 6 230 V drives of sun shading products.

Adjustable

Time mode and permanent mode: the corresponding logic behaviour can be set directly on the device.

Practical

The motor control units and the central control unit are connected by the control line. The control voltage of 24 V facilitates the use of a light current conductor (J-Y(St)Y).
  • Direct control of three 230 V sun shading drives via a sun shading control system and a local push button.
  • Multiple motor control units can be combined into a group and controlled jointly with one push button.
  • The operating mode of the Push button can be switched between time mode and permanent mode.
  • ZL: In time mode, the MSE enters lock mode after the push button is pressed for approx. 2 seconds. Operating the push button briefly generates a tilting impulse (on slat products).
  • PL: In permanent mode, the MSE enters lock mode immediately after the push button is pressed (for fabric products/roller shutters).
 Article number: 2016484

Description

Value

Operating voltage

230 V AC

Control voltage

24 V DC

Output

3 x 230 V AC

Switching capacity per drive

500 VA with 230 V AC

cos φ = 0.6

Logic behaviour

ZL PL

Degree of protection

IP 30

Safety class

I

Type of installation

Surface-mounted (AP)

Width

158 mm

Height

180 mm

Depth

60 mm