Always sending transmissions
Motor control unit transfers commands of the central control unit or of the local push button to up to 6 24 V sun shading drives.
Logically operable
Time mode and permanent mode: using the push button, the right logic behaviour for the product type can be selected.
Lockable
Protective function: locking input locks the sun shading product when the window is open.
- Direct control of up to two 24 V sun shading drives via a sun shading control system and a local push button
- Multiple motor control units can be combined into a group and controlled jointly with one push button.
- The operating mode of the Push button can be switched between time mode and permanent mode.
- ZL: In time mode, the MSE enters lock mode after the push button is pressed for approx. 2 seconds. Operating the push button for a shorter duration generates a tilting impulse (on slat products).
- PL: In permanent mode, the MSE enters lock mode immediately after the push button is pressed (for fabric products/roller shutters).
- “Fan out” program (complete slat tilting after stop or 3 minutes run time) in order to ensure the correct position of the slats.
- Locking input allows the sun shading drive to be locked, e.g. when a window is opened.
Description
Value
Operating voltage
24 V DC
Control voltage
24 V DC
Output
2 x 24 V DC
Switching capacity per drive
3 A at 24 V DC
Logic behaviour
ZL PL
Degree of protection
IP 30
Safety class
III
Type of installation
DIN rail-mounted (REG)
Subassembly width
6 MW
Power supply unit for supplying extra low-voltage consumer loads
Power supply unit for supplying extra low-voltage consumer loads
Power supply unit for supplying extra low-voltage consumer loads
Power supply unit for supplying extra low-voltage consumer loads