Flush-mounted radio receiver for directly controlling 230 V AC sun shading drives via an EWFS transmitter
Direct
Receives commands from all EWFS transmitters and sensors and directly controls a 230 V sun shading drive.
Brings elements together
Controls a drive which depends on a central control system or an EWFS transmitter.
Compact
Installation in a flush-mounted box for an unobtrusive and uncomplicated assembly.
- Floating contacts
- Permanent mode for controlling fabric products and roller shutters
- 24 V DC is supplied via an existing central control line, a floor distribution control or a 24 V DC power supply unit
- Control possible with a sun shading control system, e.g. Wisotronic, via central input (24 V DC)
- Compact design enables installation in a flush-mounted box
Description
Value
Operating voltage
24 V DC
Control voltage
24 V DC
Output
floating
Switching capacity per drive
max. 700 VA at 230 V AC
Transmission frequency
433,92 MHz
Logic behaviour
PL
Run time up/down
3 minutes
Degree of protection
IP 20
Safety class
II
Type of installation
Flush-mounted (UP)
Width
49 mm
Height
49 mm
Depth
30 mm
Junction box without terminals
Power supply unit for supplying extra low-voltage consumer loads
Power supply unit for supplying extra low-voltage consumer loads
Power supply unit for supplying extra low-voltage consumer loads
Power supply unit for supplying extra low-voltage consumer loads
Device for the operation of motor control units of up to four facades or groups via a higher-level central control unit or for facades on an individual floor via operation on different storeys